High-power fiber lasers for geothermal, oil, and gas industries
The concept of using lasers to drill through rock has been discussed in the oil and gas industries since the development of the high-power laser. Mauer's book on advanced drilling techniques summarized the early attempts to develop a CO2-based laser drill in the 1960s, but concluded that the technology was premature because of its size and complexity.1 In 2002, Ramona Graves from the Colorado School of Mines (CSM) demonstrated the potential of laser drilling by destroying a rock with a mid-IR advanced chemical laser, and later characterized the ability of a high-power diode laser to drill through rock.2 At the time, however, there were still substantial gaps in the technology that prevented commercial development. The innovation that opened up the prospect of commercializing laser drilling was the introduction of a 10kW fiber laser by IPG Photonics in 2008. A year later, with the assistance of CSM, we started developing a laser drilling process capable of creating a commercial grade borehole, along with the supporting technology necessary to field a laser drilling system.
Our drill bit features a rotating laser beam that fractures and weakens the rock, combined with a set of PDC cutters that scrape the weakened rock from the area that is exposed to the laser beam.5, 6 The laser energy that exits the drill bit creates a unique pattern on the rock that is rotated—much like a radar sweep—to heat up the bottom surface of the borehole (see Figure 1). The laser effectively spalls the surface of the rock, and in doing so introduces microfractures that enable easy removal of the layer of fractured rock. Since the strength of the rock is reduced from its >30ksi compressive strength to less than a few hundred psi during this process, it takes very little mechanical energy to ultimately remove the rock. For example, a conventional tri-cone bit requires over 25,000lbs of weight on the bit to penetrate rock with >30ksi compressive strength. Our drill bit is capable of penetrating the same rock at 2–3× the rate of penetration, but with less then 1500lbs of weight on bit while being rotated with less than 100ft-lbs of torque and using less than 10hp during the drilling process. We have successfully drilled through all of the rocks found in oil, gas, and geothermal applications with 4, 6, and 8.5” diameter bits. We have also successfully integrated the laser drill into a drilling rig and demonstrated boring a 12' hole through dolomite with a compressive strength of 30ksi (see Figure 2).
The goal of this work was to demonstrate improved speeds for drilling through ultra-hard crystalline rock compared to a conventional drilling system, which in turn reduces the cost of drilling geothermal wells. With our partners the Department of Energy's Advanced Research Projects Agency - Energy (ARPA-E) and CSM, we have demonstrated a laser-based drilling process with a faster rate of penetration (2–3×) and substantial decrease in the weight on bit (>25×) that ultimately leads to a longer bit lifetime. Our next step is to perform drilling tests at higher power levels to characterize the scalability of the drilling process.
This report was prepared as an account of work sponsored by an agency of the United States Government. Neither the United States Government nor any agency thereof, nor any of their employees, makes any warranty, express or implied, or assumes any legal liability or responsibility for the accuracy, completeness, or usefulness of any information, apparatus, product, or process disclosed, or represents that its use would not infringe privately owned rights. Reference herein to any specific commercial product, process, or service by trade name, trademark, manufacturer, or otherwise does not necessarily constitute or imply its endorsement, recommendation, or favoring by the United States Government or any agency thereof. The views and opinions of authors expressed herein do not necessarily state or reflect those of the United States Government or any agency thereof.
Mark Zediker gained his PhD from the University of Illinois in 1984 and worked at McDonnell Douglas from 1983 to 1998 on high-power laser systems. He founded Nuvonyx in 1998 to bring high-power diode laser technology to the industrial marketplace, before co-founding Foro Energy in 2009 to develop high-power laser applications in the geothermal, oil, and gas industries.